Attic leak tracing
Damp insulation, dry ceiling
Drip edge is the L-shaped metal at the eaves and rakes that throws water clear of the fascia and into the gutter. Without it, water tracks back along the underside of the shingle edge and runs down the fascia board, which is the single most common reason fascia rots. It is inexpensive, it is required by most current codes, and it is routinely missing on older roofs — so it is worth checking whenever fascia or gutter work is being done.
Candler County sits close enough to the water that salt air is part of the roofing equation, and it is the part most people miss. Salt accelerates corrosion on every metal component up there — flashing, fasteners, drip edge, vent collars — so the parts of a roof that are supposed to outlast the shingles often do not. Add hurricane exposure, where Candler County takes both the wind and the horizontal rain that comes with it, and the older housing stock near the water with its steeper pitches, slate and tile sections and complex roof geometry, and the result is a market where leaks cluster at the junctions rather than in the open field of the roof.
It is why the fascia rots. Water clings to the underside of the shingle edge and tracks back onto the timber instead of dropping into the gutter. Retrofitting it is cheap compared with replacing fascia repeatedly.
At the eaves it can often be slid under the first shingle course. At the rakes it needs to go under the underlayment, which usually means lifting the edge courses. Both are localised jobs.
Damp insulation, dry ceiling
Self-adhering membrane at vulnerable points
Concrete and clay tile
Rubber flat roofing
Full tear-off and new covering
Algae streaking and moss growth
You will get a straight answer on whether Candler County needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (229) 592-0097